D) Operation - Renkforce RF100 XL Operating Instructions Manual

• Before conducting any repair or modification work, disconnect the printer from the mains and computer
and allow it to cool down.
• Do not touch the mains cable if there are any signs of damage. If the mains cable is damaged, isolate
the mains socket (e.g. switch off the circuit breaker and RCD), and then unplug the mains plug from the
mains socket. Do not use the printer with a damaged mains cable.

d) Operation

• Do not use the 3D printer outdoors.
• Do not use the printer near bath tubs, showers, swimming pools or washbasins. It must not be exposed
to moisture.
• Some parts of the printer can become very hot and may cause burns. Exercise caution in the
presence of children and vulnerable people.
• The nozzle (for item no. 1592620 and 1592461) and hot plate (for item no. 1592461) become very hot
during use. Never touch these parts during or shortly after use. Allow them to cool down sufficiently
(approx. 60 mins).
• Do not place any objects on the printer, as this may cause it to overheat. Never cover the printer during
use.
•
• Before conducting any repair or maintenance work, disconnect the printer from the power supply (unplug
the power adapter) and allow it to cool down.
• The printer makes a noise during use and may produce an odour depending on the type of filament
material used. Bear these points in mind when selecting a setup location and choosing the filament
material. Ensure that there is sufficient ventilation, or install an extraction system. Avoid inhaling the
vapours produced by the printer. Other filament materials that are not recommended may produce
poisonous vapours or gases.
• Do not operate the device when it is unattended.
• Only use the product in temperate climates. It is not suitable for use in tropical climates.
• Never use the product immediately after it has been brought from a cold room into a warm one. The
condensation generated may destroy the product. Allow the product to reach room temperature before
connecting it and putting it to use. This may take several hours.
Never place your hands inside the 3D printer during use. The printer contains
moving mechanical parts that may cause an injury.
11