B) Setup; C) Mains Cable/Connection - Renkforce RF100 XL Operating Instructions Manual

• If you have questions which remain unanswered by these operating instructions, contact our technical
support service or other technical personnel.

b) Setup

• Place the 3D printer on a level, horizontal surface of a sufficient size.
• Install the 3D printer in a location that is out of the reach of children.
• Ensure that the power switch on the printer is easily accessible so that you can switch it off quickly in
the event of a fault.
• Do not expose the printer to extreme temperatures, strong vibrations, high humidity (e.g. rainwater or
steam) or strong mechanical loads.
• Never place containers (e.g. glasses or vases) filled with liquid on or directly next to the printer or pour
liquids over the appliance. Liquids may come into contact with the interior components and impair the
electrical safety of the product or cause a fire or fatal electric shock.
If the printer comes into contact with liquids, isolate the mains socket (e.g. switch off the circuit breaker
and RCD), and then unplug the mains plug from the mains socket. Disconnect all cables from the printer.
Discontinue use and take the printer to a specialist repair centre.
• Do not place open flames (e.g. burning candles) on or next to the printer.

c) Mains cable/connection

• The mains socket that the printer is plugged into must be easily accessible.
• Only power the product using the mains adapter provided.
• Only insert the mains adapter into a standard mains socket that is connected to the public grid. Before
plugging in the power adapter, check whether the voltage stated on the power adapter complies with the
voltage of your electricity supplier.
• Fully unwind the mains cable before use, otherwise the cable may overheat and cause a fire!
• Never connect or disconnect the power adapter if your hands are wet.
• Never unplug the power adapter from the mains socket by pulling on the cable. Always use the grips
on the plug.
• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or subjected to
mechanical stress. Avoid excessive thermal stress on the mains cable from extreme heat or cold. Do not
attempt to modify the mains cable, as this may cause permanent damage. Damaged mains cables can
cause a fatal electric shock.
• Do not allow the mains cable to hang over the edge of the table or other surface supporting the 3D
printer.
• Always lay the cables so that nobody can trip over or become entangled in them, as this may cause an
injury.
• For safety reasons, disconnect the power adapter from the mains socket during storms.
• Unplug the power adapter if you do not plan to use the 3D printer for an extended period.
• Always disconnect the power adapter before leaving the printer unattended.
10