Before Installation; Assembly; A) Setting Up The 3D Printer; B) Installation And Connection - Renkforce RF100 XL Operating Instructions Manual

10. Before installation

• Carefully remove all parts from the packaging.
• Remove the protective film from the colour touch display.
• Cut the cable ties on both sides using a wire cutter.
• Ensure that no parts are missing or damaged. Do not use the printer if parts are missing or damaged.

11. Assembly

a) Setting up the 3D printer

When choosing a location for the 3D printer, ensure that the power switch is easily accessible so that you
can switch it off quickly in the event of a fault.
Ensure that there is sufficient ventilation around the printer. Do not place the printer on soft surfaces (e.g.
rug or bed). The air must be able to circulate freely and must not be obstructed by other objects. This would
prevent heat from dissipating from the printer and lead to overheating (fire hazard).
Place the printer on a stable surface and ensure that it is securely in place. It may cause an injury if it falls
off the surface.
Ensure that the USB and mains cable are not pinched or damaged by sharp edges.
Lay the cables in a place where people will not trip over them or become entangled. This may cause an
injury.
• Place the 3D printer on a dry, level surface that is not sensitive to vibrations.
Anti-slip feet are attached to the bottom of the printer. If necessary, place a protective cover underneath the printer
to prevent the surface from getting scratched.

b) Installation and connection

The mains socket must be close to the printer and easily accessible so that you can quickly
disconnect the printer from the mains in the event of a fault.
Exercise caution when handling the mains cable and connecting it to the mains. Mains voltages
can cause fatal electric shocks.
Before connecting the printer to the mains, check that the voltage stated on the printer matches
the voltage of the mains socket. If not, do not connect the printer to the mains. An incorrect mains
voltage can cause irreparable damage to the printer and endanger the user.
14