Disposal; Technical Data; A) General Information - Renkforce RF100 XL Operating Instructions Manual

Problem
You cannot configure any settings on the
control panel.
The firmware does not update.

20. Disposal

Electronic devices are recyclable waste and must not be placed in household waste. At the end of its
service life, dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

21. Technical data

a) General information

System requirements ............................Windows
Dimensions (W x H x D) .......................Max. 200 x 200 x 200 mm
Layer resolution ....................................0.1 - 0.2 mm
Print speed ...........................................30–300 mm/s
Interfaces ..............................................USB 2.0 and SD card reader
Printing method ....................................Melting of filament materials
Print format ............................................GCODE
Nozzle (ø) .............................................0.4 mm
Filament (ø) ..........................................1.75 mm
Extrusion temperature ..........................+180 to +260 °C
Compatible with "Cura" software ..........Version 15.04.6 or lower
Operating conditions .............................+15 to +55 °C, 30–90 % relative humidity (non-condensing)
Storage conditions ................................+5 to +35 °C, 30–90 % relative humidity (non-condensing)
Dimensions (W x H x D) .......................370 x 397 x 417 mm
Weight ..................................................15.15 kg
60
Possible solution
Check the connection source. Go to the < ReadyPrint > menu. Select
< SelectSource >, and then select < 115200 > (to control the 3D printer
via the control panel).
Check whether the SD card contains the update files for the last
firmware update. If so, delete these files from the SD card.
XP or higher, Mac OS 10.6.8 or higher
®