Performing/Changing Wired Lan Settings - Canon TX-2000 Online Manual

Performing/Changing Wired LAN Settings

Follow the procedure below to perform/change wired LAN settings.
Note
• For some models, you can perform network setup for a USB connected printer using IJ Network Device
Setup Utility. Select USB on Switch View under the View menu to display printers for which you can
perform setup.
1. Start up IJ Network Device Setup Utility.
2. Check the displayed message and select Yes.
3. Select Printer Network Setup on the displayed screen.
Detected printers are listed.
4. Select printer to perform/change settings from printer list.
Select the printer with Wired LAN displayed on Connection Method and the setting other than
Unknown, Not Connected, or Setup Completed displayed on Status to perform settings.
To perform setup for a USB connected printer, select USB from the pulldown menu on the toolbar and
select the printer with Wired LAN displayed on Connection Method.
5. Select Network Settings... on Printer Settings menu.
The Confirm Printer Password screen appears.
For more on the password, refer to Administrator Password.
Note
• Clicking the
6. Enter password and click OK.
The Network Settings screen appears.
7. Perform/change settings.
You can switch the screen between IPv4 and IPv6. Click the tab to switch the protocol.
• IPv4 settings
icon allows you to perform/change settings.
375