Advertisement
FUEL SYSTEM
DISASSEMBLY
NOTICE
• Do not remove the
sensor
unit unless
it
is replaced.
• The throttle body/sensor unit is factory
pre-set.
Do
not disassemble in a way other than
shown
in this
manual.
• Do not snap the throttle valve from full
open
to full
close
after the throttle cable has been removed. It
may cause incorrect idle
operation.
• Do not damage the throttle body. It may cause
incorrect throttle valve operation.
• Do not loosen
or
tighten the white painted nut and
screw [1]
of
the throttle body.
Loosening or
tightening
it
can cause throttle valve and idle control
failure.
• Always clean around the throttle body before each
sensor removal to prevent dirt and debris from
entering the air passage.
NOTE:
-
For injector removal (page 7-20).
-
For IACV removal (page
7-22).
Remove the throttle body insulator [2].
Remove the sensor unit torx screws [1], sensor unit [2]
and 0-ring [3].
Cleaning the air
Clean the air passage of the throttle body using a
passages
and
compressed air.
sensor
hole
with
a
Check the air passage for clogs.
piece of wire
will
damage
the throttle
body.
7-16
[2]
[1]
[3]
[2]
Advertisement
