Advertisement
Install a new packing [1] into the cylinder head
cover
[2]
groove.
Install the
cylinder
head cover onto the cylinder head.
Check the rubber seals [1] are in good
condition,
replace them if necessary.
Install the rubber seals to the cylinder head cover
with
their
"UP"
marks [2] facing
up.
Install and tighten the
cylinder
head
cover
bolts [1] to
the specified torque.
TORQUE:10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the following:
-
PAIR check valve
(page
7-24)
-
Spark plug cap
(page 3-6)
CAMSHAFT
REMOVAL
The
camshaft can
Remove the
cylinder
head cover
(page
10-6).
be serviced with the
Make sure the piston is at TDC
(Top
Dead Center) on
engine installed in
the compression stroke
(page 3-8).
the frame.
Remove the
cam
chain tensioner lifter plug [1] and 0-
ring [2].
CYLINDER HEADNALVES
[2]
[1]
10-7
Advertisement
