Advertisement
-----------~·---·------
FUEL SYSTEM
FUEL LINE INSPECTION
FUEL PRESSURE RELIEVING
NOTE
Before disconnecting fuel feed hose
,
relieve pressure from the system as follows.
7-4
1.
Turn the ignition switch OFF.
2.
Remove the side cover (page
2-9).
3. Disconnect the fuel pump 5P connector [1]
.
Turn the ignition switch ON and engine stop switch
"o
".
4.
Start the engine
,
and let it idle until the engine
stalls.
5.
Turn the ignition switch OFF.
6.
Disconnect the battery negative
H
cable (page 20-
5).
QUICK CONNECT FITTING REMOVAL
NOTE
Do not bend or twist fuel feed hose.
1. Relieve the fuel pressure (page 7-4 ).
2.
Check the fuel quick connect fitting [1] for dirt, and
clean if
necessary.
Place a shop towel over the quick connect fitting
.
Push the retainer tab [2] forward.
3.
Press down the retainer [1] and hold
.
Disconnect the connector [2] from the fuel pump
joint/injector joint.
Check the retainer condition and replace it if
necessary.
NOTE:
Prevent the remaining fuel in the fuel feed hose from
flowing
out,
using a shop towel.
• Be careful not to damage the hose or other
parts.
• Do not use tools
.
• If the connector does not move
,
alternately pull and
push the connector until it comes off easily.
[1)
[1)
[2)
Advertisement
