Advertisement
FRONT WHEEL/SUSPENSION/STEERING
Drive the oil seal [1] until the stopper ring groove [2] is
visible using the special tools
.
TOOLS:
Fork seal driver [3]
07747-0010100
Fork seal driver attachment [4]
07747-0010600
U.S.A. TOOLS:
Fork seal driver, 37 mm
07947-3710101
Install the stopper ring
[1]
into the groove of the fork
slider
securely.
Apply fork fluid to a new dust seal lips.
Install the dust seal
[2].
Pour the specified amount of recommended fork fluid
into the fork
pipe.
RECOMMENDED FORK FLUID:
Pro Honda Suspension Fluid SS-8 (10W)
FORK FLUID CAPACITY:
CBR300R/RA:
331
±
2.5 cm
3
(11 .2
±
0.08 US oz, 11.7
±
0.09 Imp oz)
CB300F/FA:
311
±
2.5 cm
3
(10.5
±
0.08 US oz, 10.9 ± 0.09 Imp oz)
Slowly pump the fork pipe several times to remove any
trapped air from the lower portion of the fork pipe.
Compress the fork pipe fully and measure the fluid level
from the top of the fork pipe.
FLUID LEVEL:
CBR300R/RA: 150 mm (5.9 in)
CB300F/FA: 146 mm (5.7 in)
Pull the fork pipe up and install the fork spring [1]
with
the tightly wound coil side facing down.
Install the spring seat [2] and spring collar [3].
[3]
[2]
[1]
DOWN
150
mm
(5.9
in)
16-27
Advertisement
