Advertisement
FUEL FLOW INSPECTION
Relieve the fuel pressure and disconnect the quick
connect fitting (page 7-4 ).
Wipe off spilled
Connect the special tool to the fuel pump joint.
gasoline.
TOOLS
:
Hose attachment, 6 mm/9 mm [1] 07ZAJ-S5A0130
Fuel pressure manifold
07AMJ-HW3A100
Place the end of the hose into an approved gasoline
container.
Temporarily connect the battery negative (-)cable and
fuel pump 5P
connector.
Turn the ignition switch ON and engine stop switch
"O".
Measure the amount of fuel
flow.
NOTE:
• The fuel pump operates for 2
seconds.
Repeat 5
times so that the total measuring time.
Return fuel to the fuel tank when the first fuel is
flowed
.
Amount of fuel flow:
69.2 cm
3
(2.34 US oz, 2.44 Imp oz) minimum/10 seconds at 12 V
If fuel flow is less than specified
,
inspect the following:
-
Fuel pump unit (page 7-8)
-
Clogged fuel filter
Connect the quick connect fitting (page 7-5).
FUEL TANK
REMOVAL/INSTALLATION
Relieve the fuel pressure and disconnect the quick
connect fitting (page 7-4
).
Release the fuel feed hose [1] from the hose guide [2]
.
Release the clamp [3] from the setting plate.
Remove the bolts [4], collar [5], washers [6]
,
mounting
rubbers [7] and fuel tank [8]
.
NOTE:
Place the suitable support under the front side of the
removed fuel tank to avoid damage the fuel filter.
[1]
Install the fuel tank in the reverse order of removal.
Connect the quick connect fitting (page 7-5).
FUEL SYSTEM
[1]
[7]
7-7
Advertisement
