Advertisement
FRONT WHEEL/SUSPENSION/STEERING
Install the right handlebar [1) over the fork tube, aligning
the boss with the groove in the top bridge
.
Be sure the handlebar holder is fully seated on the top
bridge. Push the handlebar forward to touch the boss
against the inside of the groove, then tighten the pinch
bolt [2) to the specified torque.
TORQUE: 27 N·m
(2.8
kgf·m, 20 lbf·ft)
Install the stopper ring [3] into the groove in the fork
tube.
Install the lower right handlebar switch housing [1) by
aligning the locating pin with the hole in the handlebar.
Install the upper right handlebar switch housing
.
Tighten the upper screw first [2)
,
then tighten the lower
screw [3) to the specified torque
.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf-ft)
Align the edge
of
Install the master cylinder [1] and holder [2] with the
the master cylinder
"UP"
mark [3] facing up. Tighten the upper bolt first [4],
with the punch
then the lower bolt [5] to the specified torque
.
mark on the
handlebar.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbMt)
16-12
Connect the brake light switch connectors [6].
Install the handlebar weight [1 ], aligning the flats and
tighten the screw [2] while holding the weight
securely.
Check the throttle grip freeplay (page 3-4 ).
Advertisement
