Advertisement
FRONT WHEEL/SUSPENSION/STEERING
Allow the adhesive
to dry for 1 hour
before using.
Clean the inside surface of the left handlebar grip [1]
and the outside surface of the handlebar [2].
Apply Honda Bond A or equivalent to the inside surface
of the grip and to the outside surface of the handlebar.
Wait 3 - 5 minutes and install the
grip.
Rotate the grip
for even application of the adhesive.
Install the handlebar weight [3]
,
aligning the flats and
tighten the screw [4] while holding the weight securely.
Install the left handlebar switch housings [1] by aligning
the locating pin with the hole in the handlebar. Tighten
the upper screw first [2]
,
then tighten the lower screw [3]
to the specified torque.
TORQUE:
2.5
N·m
(0.3
kgf·m,
1.8
lbf·ft)
Align the edge of
Install the clutch lever bracket [1] and holder [2] with the
the bracket with the
"UP" mark [3] facing up. Tighten the upper bolt first [4],
punch mark on the
then the lower bolt [5]
.
handlebar.
Connect the clutch switch connectors [6].
Install the connector boot [7]
over
the bracket sleeve.
Check the clutch lever freeplay (page 3-21
).
RIGHT HANDLEBAR
Clean the sliding surfaces of the throttle grip [1] and
right handlebar [2].
Apply grease to the cable groove and roll-up area of the
throttle grip.
Connect the throttle cables [3] to the throttle grip and
set the throttle grip into the lower right handlebar switch
housing [4]
.
Install the throttle grip onto the handlebar.
[1]
16-11
Advertisement
