Advertisement
FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION (C8300F/FA)
Clean the sliding surfaces of the throttle grip [1] and
right handlebar [2].
Apply grease to the cable groove and roll-up area of the
throttle
grip.
Connect the throttle cables [3] to the throttle grip and
set
the throttle grip into the lower right handlebar switch
housing [4].
Install the throttle grip onto the handlebar.
Align
the
punch
Install the handlebar [1] and holder [2]
.
Tighten the front
mark
with
the
edge
bolts [3] first, then tighten the rear bolts [4] to the
of
the top
bridge.
specified torque
.
TORQUE:27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the lower right handlebar switch housing [1] by
aligning the locating pin with the hole in the handlebar.
Install the upper right handlebar switch housing [2]
.
Tighten the upper screw first [3], then tighten the lower
screw [4] to the specified torque
.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
Align
the
edge
of
Install the master cylinder [1] and holder [2] with the
the master
cylinder
"UP"
mark [3] facing up. Tighten the upper bolt first [4]
,
with
the punch
then the lower bolt [5] to the specified torque.
mark
on
the
handlebar.
TORQUE:12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the brake light switch connectors [6].
16-13
Advertisement
