Advertisement
CRANKCASE/CRANKSHAFT/TRANSMISSION/BALANCER
BEARING REPLACEMENT
BALANCER/TRANSMISSION BEARING
14-20
Remove the following:
-
Crankshaft
(page
14-7)
-
Balancer shaft
(page
14-18)
-
Transmission
(page
14-13)
RIGHT CRANKCASE SIDE
Remove the bolts [1] and mainshaft bearing setting
plate [2].
Drive out the mainshaft bearing [3], shift drum bearing
[4] and balancer shaft bearing [5]
.
Remove the
countershaft
bearing [1] using the special
tools.
TOOLS:
Bearing remover set, 17 mm [2] 07936-3710300
Remover handle
07936-3710100
Remover weight [3]
07741-0010201 or
07936-371020A
(U.S.A. only)
Drive in new bearings into the right crankcase until they
are fully seated using the special tools.
TOOLS:
Mainshaft bearing [1] (marked side facing up):
Driver [2]
077 49-0010000
Attachment, 52 x 55 mm [3]
07746-0010400
Pilot, 20 mm [4]
07746-0040500
Countershaft bearing [5] (sealed side facing down):
Driver
077 49-0010000
Attachment, 37 x 40 mm
07746-0010200
Pilot, 17 mm
07746-0040400
Shift drum bearing [6] (marked side facing up):
Driver
077 49-0010000
Attachment, 42 x 47 mm
07746-0010300
Advertisement
