™
APEX
and APEX Sentry
Using the Setup
Function
Figure 3-22. RCT workspace/
Setup Info
3-28
™
Radar Gauge
To install the APEX Radar Gauge by using the Setup function do the
following:
Basic
Setup
1. Start the RCT software.
2. In the RCT workspace click the Setup icon (make sure the Basic section
is open)
3. Choose the appropriate tab:
•
Info: Information about the device.
•
Basics: Set measurement units.
•
Output: Variable assignment and range value settings.
•
Tank Config: Tank height and other geometry settings, null zones, and
empty tank settings.
•
Volume: Specification of tank geometry for volume calculations.
•
LCD: Display panel settings.
•
Advanced: Quick pick options and their required parameter settings.
Reference Manual
00809-0100-4731, Rev FA
April 2003