Honda Activa SCV110 Service Manual Digest page 116

KICKSTARTER/DRIVE AND DRIVEN PULLEYS/CLUTCH
Install the kickstarter pedal in its original position as
BOLT KICKSTARTER PEDAL
marked during removal and tighten the bolt (1 no.).
TORQUE: 29 N·m (3.0 kgf·m,22 lbf·ft)
MARK
Install the thrust washer onto the crankcase cover.
THRUST WASHER
Apply grease (0.2 – 0.3 g) to the driven gear shaft and
DRIVEN GEAR
friction spring sliding area.
Turn the kickstarter pedal and hold it.
Install the driven gear while aligning the friction spring
hook with the groove in the crankcase cover, and return
the pedal to engage the driven gear and spindle gear.
FRICTION SPRING
Install the left crankcase cover plate and tighten the
SCREWS
screws (5 nos.).
TORQUE: 3 N·m (0.3 kgf·m, 2.2 lbf·ft)
Bend the lock tabs of the cover plate against the screw
heads.
COVER PLATE
9-7