Frame/Body Panels/Exhaust System - Honda Activa SCV110 Service Manual Digest

2. FRAME/BODY PANELS/EXHAUST SYSTEM

BODY PANEL LOCATIONS
SERVICE INFORMATION
TROUBLESHOOTING
FRONT CENTER COVER
FRONT COVER
SEAT
BODY COVER LIFT UP
BODY COVER
FLOOR MAT/FLOOR PANEL
SERVICE INFORMATION
GENERAL
Serious burns may result if the exhaust system is not allowed to cool before components are removed or serviced.
• This section covers removal and installation of the body panels and exhaust system.
• Always replace the exhaust pipe gasket after removing the exhaust pipe from the engine.
• When installing the exhaust system, loosely install the exhaust pipe fasteners. Always tighten the exhaust pipe fasteners first,
then tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat properly.
• Always inspect the exhaust system for leaks after installation.
TORQUE VALUES
Muffler mounting bolt
Muffler protector mounting bolt
TROUBLESHOOTING
Excessive exhaust noise
• Broken exhaust system
• Exhaust gas leak
Poor performance
• Deformed exhaust system
• Exhaust gas leak
• Clogged muffler
2-0 INNER COVER
2-1 UNDER COVER
2-1 REAR FENDER
2-2 HANDLEBAR COVER
2-2 MUFFLER
2-2 MUFFLER PROTECTOR
2-3 SARI STEP
2-4 SIDE STAND
2-5
49 N·m (5.0 kgf·m, 36 lbf·ft)
14 N·m (1.4 kgf·m, 10 lbf·ft)
2-6
2-6
2-7
2
2-7
2-8
2-8
2-9
2-10
2-1