FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Remove the dust seal from the right side of wheel.
Insert the bearing remover head into the bearing.
From the opposite side install the bearing remover shaft
and drive the bearing out of the wheel.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover head, 12 mm
Bearing remover shaft
Replace the wheel bearings in pairs.
Remove the nuts (4 nos.) and wheel hub.
INSPECTION
FRONT AXLE
Set the front axle in V-blocks and measure the runout
using a dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMIT: 0.20 mm (0.008 in)
13-4
070GD – 005-I130
070GD – 005-I100
REMOVER SHAFT
REMOVER HEAD
WHEEL HUB
DUST SEAL
NUTS
AXLE BOLT