Installing A Mini Pcie Card - DFI EC70B-SU Installation Manual

Hide thumbs Also See for EC70B-SU:

Installing a Mini PCIe Card

The system board is equipped with 2 Mini PCIe slots: one full-size and one half-

size slot. Here we will demonstrate the installation of a full-size Mini PCIe card.

The PCIe sockets are located on the main board; to access the main board, detach

the expansion board on top of it. Remove the screws that affix the front and

back bezels as shown in the following pictures to access the expansion board and

uninstall it from the system.

Use a wrench to remove the

hexagonal gasket

2. Grasp the Mini PCIe card by its edges and align the notch of the PCIe card

with the key in the connector on the system board.

3. Push the Mini PCIe card down and use the provided mounting screw to secure

the card on the system board.

Note:

The system also has a half-size Mini PCIe slot that can accommodate either a Mini PCIe or an mSATA card. Refer

to jumper settings for signal selection for this slot.

Use a wrench or a screwdriver with a

socket end to remove the fasteners

used on DE9 and VGA connectors.

Mounting Screw

Table of Contents