Adjustment/Maintenance - Kyocera ECOSYS M8124cidn Operation Manual

Default Setting of FAX [System Menu] > System Menu Settings
ECM RX
RX Start Speed
[TX/RX Restriction]
This function allows you to send or receive originals only when communication requirements are met.
Transmission Restriction (8-13)
[Forward Settings]
When you have received a fax, you can forward the received image to other faxes and computers or specify a number of
copies.
Memory Forwarding (5-12)
[New Destination Entry (FAX)]
Item
New Destination Entry
(FAX)

Adjustment/Maintenance

Adjust printing quality and conduct machine maintenance.
Service Setting
Item
FAX Call Settings(Europe only)
Exchange Selection
Dial No. to PSTN
Item
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax
machines that have ECM mode check for errors as they communicate, preventing
distortion of the image due to noise on the line and other conditions.
Value: On, Off
When there is a large amount of noise on the line, communication may take slightly
longer than when [
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In
that case, set a lower RX Start Speed.
Value: 9600bps, 14400bps, 33600bps
Normally this should be used with the default setting.
Select whether to permit direct entry of destination. When this option is set to [Prohibit], you
cannot enter the destination directly.
Value: Permit, Prohibit
When using this machine in environment in which PBX for connection to multiple phones for
business use is installed, perform the following PBX setting.
If the machine is connected to a PBX, set [PBX].
Value: PBX, PSTN
Set a number to access an outside line. For the number, contact the PBX administrator.
Value: 0-9, 00-99
Description
] is selected.
Off
Description
Description
8-12