Indicators During Sending/Receiving Operation - Kyocera ECOSYS M8124cidn Operation Manual

Troubleshooting > Indicators During Sending/Receiving Operation

Indicators During Sending/Receiving Operation

The [Processing] and [Memory] indicators show the fax transmission status.
• The [Processing] indicator blinks during fax transmission and reception.
• The [Memory] indicator blinks when source data is being stored in memory for memory transmission.
• The [Memory] indicator is lit when there is source data stored in the memory for delayed transmission.
Responding to an Attention Indicator Flashes
If the [Attention] indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message is not
indicated on the touch panel when the [Status/Job Cancel] key is pressed or the attention indicator flashes for 1.5
seconds, check the following.
Symptom
Cannot send fax.
Checkpoints
Is the modular cord
connected correctly?
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Has a communication
error occurred?
Is the destination FAX line
busy?
Does the destination FAX
machine respond?
Is there an error other
than above?
10-2
Corrective Action
Connect the modular cord correctly.
Check Permitted FAX No. and Permitted ID No.
Check error codes in the TX/RX Result Report
and Activity Report. If the error code starts with
"U" or "E", perform the corresponding
procedure.
Send again.
Send again.
Contact your Service Representative.
Reference
Page
—
8-13
10-5
—
—
—