Filling The Ice Bin - Cornelius SPIRE 4.1 Operator's Manual

Spire 4.1 Operator's Manual
F I B
ILLING THE CE
Review the following before filling the ice bin.
Use caution to avoid spilling ice when filling the dispenser. Immediately clean up any spilled
ice from filling or operating the unit. To prevent contamination of ice, the lid must be installed on
!
the unit at all times.
WARNING
Failure to clean up spills could result in serious injury or death.
The dispenser cannot be used with crushed or flaked ice. Use of bagged ice which has frozen
into large chunks can void the warranty. The dispenser agitator is not designed to be an ice
!
crusher. Use of large chunks of ice which jam up inside the bin will cause failure of the agitator
CAUTION motor and damage to the bin. If bagged ice is used, it must be carefully and completely broken
into small, cube-sized pieces and left to "temper" or warm up for a minimum of 20 minutes at
room temperature before loading it into the ice bin.
• ) After loading the ice into the bin, wait 30 minutes to allow the cold plate to chill the syrups to
operating temperature.
!
• ) Do not overfill the ice bin hopper.
IMPORTANT
Perform the following steps to fill the ice bin.
1. Open the display door and remove the ice bin cover See Figure 12
2. Fill the bin with ice. (225 lb. MAX).
!
Important: Do not over-fill the ice bin.
3. Replace the ice bin cover and close the display door.
To do this, slide the ice bin cover over the ice bin, then close the display door.
Publication Number: 620066826OPR
IN
- 12 -
Ice Bin
Display
Cover
Door
Figure 12
© 2017, Cornelius Inc.