Cornelius SPIRE 4.1 Operator's Manual page 24

Spire 4.1 Operator's Manual
4. With each Enclave tab released from a tab hold-
ers, guide the Enclave forward and out of the
unit. Place it in a safe place.
Result: The Enclave is removed from the unit
and the service lines are exposed to support
installation and service activities.
R E
EPLACING THE
Note: Do not replace the Enclave until lines and drains are connected. Read all steps first, then, perform the following
steps to replace the Enclave.
1. To replace the Enclave, the drain pan must be in
position. Position the drain pan into the unit as
shown in Figure 42.
The drain pan is installed in the unit.
2. With the drain pan in place, tilt top of the
Enclave unit toward the inside of the unit and
position the left and right sides of the Enclave
on top of the left and right sides drain pan,
respectively.
Then, press the top of the Enclave tabs down
and back toward the tab holders until the tabs
click into place.
Result: The Enclave is installed in the unit.
Publication Number: 620066826OPR
( R
NCLAVE AS EQUIRED
)
Drain
PAN
- 24 -
Figure 41
Figure 42
Figure 43
© 2017, Cornelius Inc.