Cornelius SPIRE 4.1 Operator's Manual page 22

Spire 4.1 Operator's Manual
R CO
EPLENISHING
NOTE: When the indicator on the 1800-psi gage is in the shaded ("change CO
CO cylinder is almost empty and should be changed.
2
CO displaces oxygen. Strict attention MUST be observed in the prevention of CO
2
entire CO
!
DIATELY ventilate the contaminated area before attempting to repair the leak. Personnel exposed
DANGER to high concentrations of CO
sciousness and DEATH.
Perform the following steps to change the CO
1. Fully close (clockwise) the CO
2. Slowly loosen the CO
3. Remove the regulator assembly from the empty CO
4. Unfasten the safety chain and remove the empty CO
der.
!
WARNING
To avoid personnel injury and/or property dam-
age, always secure the CO
prevent it from falling over. Should the valve become acci-
dentally damaged or broken off, a CO
serious personnel injury or death could occur.
5. Position the full CO
6. Make sure the gasket is inside the CO
coupling nut and is properly seated.
7. Install the regulator assembly on the CO
8. Open (counterclockwise) the CO
9. Open the valve fully to back-seat the valve to prevent gas leakage around the valve shaft).
10. Check all CO connections for leaks and tighten any loose connections.
2
Publication Number: 620066826OPR
S (A R
UPPLY S
2
and soft drink system. If a CO
2
gas experience tremors which are followed rapidly by loss of con-
2
cylinder:
2
cylinder valve.
2
regulator assembly coupling nut, allowing CO
2
cylinder with a safety chain to
2
regulator can cause
2
cylinder in its proper location and secure it with a safety chain.
2
regulator assembly
2
cylinder.
2
cylinder valve slightly to allow the lines to slowly fill with gas.
2
)
EQUIRED
gas leak is suspected, particularly in a small area, IMME-
2
2
cylinder.
2
cylin-
2
- 22 -
cylinder") portion of the dial,
2
gas leaks in the
2
Figure 35
pressure to escape.
Figure 36
Figure 37
© 2017, Cornelius Inc.
Valve
Regulator
Nut
Washer