Table of Contents
Advertisement
Installation
Changing your Personal Identification Number (PIN)
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom left of
the display). This clears the top line and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
The display looks like this:
1. INSTALL
Press an up or down menu button until you reach the NEW PIN menu below, and then
press OK (or press 5, instead of an up or down menu button, to go directly to the screen
below):
5. NEW PIN
Enter your new PIN (4 digits). Press OK.
Note, choose a PIN that you are not likely to forget (a birthday, for example). If you forget
your PIN you will need to reset the system and set everything up again. See page 39.
Press Clear to back out of the menu. If you press Clear while entering numbers, before
you're finished setting the new PIN, it clears the numbers. If you press Clear after you've
set the new PIN and pressed OK, you are asked to confirm, 1. YES, 2 NO. Pressing 1
takes you back to the HOME CONTROL screen. Press 2 to stay in the INSTALL menu.
24
Installation
Clearing the memory
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom left of
the display), or enter your PIN if you changed it (see page 24). This clears the top line
and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
The display looks like this:
1. INSTALL
Press an up or down menu button until you reach the MEMORY CLEAR menu below, and
then press OK (or press 6, instead of an up or down menu button, to go into the
MEMORY CLEAR menu):
6. MEMORY
CLEAR
Press an up or down Menu button to select the desired sub-menu.
CLEAR ALL SENSORS
CLEAR ALL REMOTES
CLEAR ALL TIMERS
MASTER RESET
Select the desired sub-menu item and then press OK. Press Clear to back out of the
menu. You are asked to confirm, 1. YES, 2 NO. Pressing 1 takes you back to the HOME
CONTROL screen. Pressing 2 stays in the MEMORY CLEAR menu. Note, selecting
MASTER RESET immediately takes you back to the HOME CONTROL screen.
25
Advertisement
Table of Contents
