Table of Contents
Advertisement
FCC Caution
This equipment generates and uses radio frequency
energy, and if not installed and used properly, that is,
in strict accordance with the manufacturers instructions,
it may cause interference to radio and television
reception. It has been type tested and found to comply
with the limits for remote control devices in accordance
with the specifications in Sub-Parts B and C of Part 15
of FCC Rules, which are designed to provide
reasonable protection against such interference in a
residential installation. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause interference to radio or
television reception, which can be determined by
unplugging the equipment, try to correct the
interference by one or more of the following measures.
• Reorient the antenna of the radio/TV experiencing
the interference.
• Relocate the equipment with respect to the radio/
TV.
• Move the equipment away from the radio/TV.
• Plug the equipment into an outlet on a different
electrical circuit from the radio/TV experiencing the
interference.
• If necessary, consult your local dealer for additional
suggestions.
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFER-
ENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
This equipment complies with Part 68 of the FCC
rules and the requirements adopted by the ACTA. On
the bottom of the Console is a label that contains,
among other information, the product identifier
B4SAL04BJSC13A. If requested, this number must
be provided to the telephone company.
On the bottom of the Console is a label that
contains, among other information, the FCC
registration number and ringer equivalence number
(REN) for this equipment. If requested, this
information must be provided to the telephone
company.
The REN is used to determine the number of devices
that may be connected to a telephone line. Excessive
RENs on a telephone line may result in the devices
not ringing in response to an incoming call. In most
but not all areas, the sum of RENs should not
exceed five (5.0).
To be certain of the number of devices that may be
connected to a line, as determined by the total
RENs, contact the local telephone company.
The REN for this Console is part of the product
identifier B4SAL04BJSC13A. The digits 15 represent
the REN without a decimal point ( e.g. , 04 is a REN
of 0.4).
Use an RJ11 connector to connect the Console to
the telephone line.
A plug and jack used to connect the Console to the
premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A compliant
telephone cord and modular plug is provided with
this product. It is designed to be connected to a
compatible modular jack that is also compliant. See
installation instructions for details.
If the Console causes harm to the telephone
network, the telephone company will notify you in
advance that temporary discontinuance of service
may be required. But if advance notice isn't practical,
the telephone company will notify you as soon as
possible. Also, you will be advised of your right to file
a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes in its
facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this
happens the telephone company will provide
advance notice in order for you to make necessary
modifications to maintain uninterrupted service.
If trouble is experienced with the console for repair
or warranty information, please contact
www.x10.com/support. If the equipment is causing
harm to the telephone network, the telephone
company may request that you disconnect the
equipment until the problem is resolved.
There are no user serviceable parts in the console.
Connection to party line service is subject to state
tariffs. Contact the state public utility commission,
public service commission or corporation
commission for information.
Note 1: Modifications to this product will void the user's
authority to operate this equipment.
Note 2: The security functions of this system have
not been tested by Underwriters Laboratories.
2
Contents
Introduction .................................................................................................... 4
Installation ...................................................................................................... 5
Locating Security System components ....................................................... 5
Attaching the cables .................................................................................... 6
Fitting the backup batteries ......................................................................... 7
Wall mounting .............................................................................................. 7
Overview ......................................................................................................... 8
Registering Remotes ................................................................................. 12
Registering Door/Window Sensors ........................................................... 13
Removing Door/Window Sensors ............................................................. 14
Installing Door/Window Sensors ............................................................... 15
Registering Motion Detectors .................................................................... 16
Removing Motion Detectors ...................................................................... 17
Installing Motion Detectors ........................................................................ 18
Hard-wired Inputs ...................................................................................... 19
Setting the Clock ....................................................................................... 20
Setting the Phone Numbers ...................................................................... 21
Setting the Outgoing Message .................................................................. 22
Setting the PIN .......................................................................................... 24
Clearing the Memory ................................................................................. 25
Setting Options .......................................................................................... 26
Setting Delays ........................................................................................... 27
Setting Timers ........................................................................................... 28
Canceling Timers ...................................................................................... 30
Using the System ......................................................................................... 32
Arming and Disarming .............................................................................. 32
Problem zones .......................................................................................... 33
When there's an alarm .............................................................................. 34
Controlling Lights and Appliances ............................................................. 35
Setting up Optional Lamp Modules ............................................................ 36
Operation from an Outside Telephone ....................................................... 38
Replacing Batteries ...................................................................................... 39
Resetting the P.I.N. ....................................................................................... 40
Troubleshooting ........................................................................................... 41
Expanding your System .............................................................................. 45
3
Advertisement
Table of Contents
