Installation - GE JSC1300 Owner's Manual

Installation

Security Console
Attaching cables
A telephone cord terminated at each end with an RJ11 connector is provided for
telephone connection. If possible, the Console should be connected to its own telephone
line to ensure that the line cannot be busy when the Console attempts to dial out. For
applications where this is not practical, the Console may also share a line with an existing
telephone using a 'T' adapter (supplied).
Note: The Security Console is not designed to operate with an RJ31X type telephone
connection.
Remove the screw and open the center lid
on the Console. Attach the power supply's
cord to the connector labeled power
supply (see above). Plug the power supply
into any convenient (unswitched) AC
outlet. If you power up and then open the
lid, (not easy to do) the display shows
TAMPER (see next page).
NOTE: you must use the power supply
that came with the Security System. The
power supply contains circuitry required to
control X10 modules, so you CANNOT
replace it with a regular 8V DC power
supply.
Attach the power
supply's cord here.
Tamper Switch
(internal)
Hard Wired Inputs.
Attach the phone
cord here.
6
Installation
Fitting the backup batteries
Install 4 AA alkaline batteries (not supplied) in the battery compartment. It is not
necessary to disconnect power to the Console when fitting or replacing batteries.
Replace the battery cover and securely insert the screw.
Note, if you remove the battery cover AFTER you powered up the Console, TAMPER will
appear in the display. To remove TAMPER from the display, replace the battery cover,
securely insert the screw, and then enter your PIN (default 0000). The display then shows
HOME CONTROL in the top line and the time of day below it.
Turns on if
batteries are
low or not
installed.
Mounting the Console
The Security Console is designed to be installed freestanding, on a table top or shelf. Or
it can be wall mounted using the two slotted holes on the back of the Console.
If you don't want to wall mount the console, you can flip the feet on the Console out, so as
to tilt the Console slightly forward for better viewing of the display.
7