Table of Contents
Advertisement
Installation
Initializing Motion Detectors
Remove the cover on the front of the Motion Detector and
install 2 AA alkaline batteries in the compartment.
Replace the battery cover (the unit has a tamper switch).
Press and hold the TEST button on the back of the Motion
Detector for 3-4 seconds and then release it. This initializes
the Motion Detector and picks a random code that is used
when it is registered with the Console. Place the unit face
down, so that it won't see any motion during the registering
process below.
Registering the Motion Detector with the Console
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom left of
the display), or enter your PIN if you changed it (see page 24). This clears the top line
and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
When you see INSTALL on the display, press OK. The display then looks like this:
INSTALL
ZONE
16
Installation
Now simply press the TEST button on the back of the Motion Detector (or turn the unit
over so that it sees motion). The Console will acknowledge that it has been registered by
displaying (for example) ZONE 3 SET.
Repeat this for any other Motion Detectors you want to register. The display increments to
ZONE 4 SET, etc. as you register more Motion Detectors.
If desired, you can specify what zone you want the Motion Detector to be installed into.
Just press the number of the zone you want on the Console's keypad, before you press
the TEST button on the back of the Motion Detector.
Press Clear to back out of the menu. You are asked to confirm, 1. YES, 2 NO. Pressing 1
takes you back to the HOME CONTROL screen. Press 2 to stay in the INSTALL menu.
Removing Motion Detectors
Follow the steps above to install a Motion Detector. When the display shows:
INSTALL
ZONE
Press the number of the zone you desire (just as if you were going to register the Motion
Detector into that zone) but instead of pressing the TEST button on the Motion Detector
(to register it) press CLEAR on the Console's keypad. The display ask you to confirm the
deletion:
CLEAR ZONE
1. YES 2. NO
Pressing 1 on the Console's keypad changes the display to:
INSTALL
ZONE 13 OUT
Where 13 is the zone you selected. Pressing 2 instead takes you back to the INSTALL
ZONE screen.
Press Clear to back out of the menu. You are asked to confirm, 1. YES, 2 NO. Pressing 1
takes you back to the HOME CONTROL screen. Press 2 to stay in the INSTALL menu.
17
Advertisement
Table of Contents
