Setting Timers - GE JSC1300 Owner's Manual

Installation
Setting Timers to turn lights on and off (requires X10/GE Modules)
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom left of
the display), or enter your PIN if you changed it (see page 24). This clears the top line
and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
The display looks like this:
1. INSTALL
Press an up or down menu button until you reach the SET TIMER menu below, and then
press OK (or press 9, instead of an up or down menu button, to go to the NEW TIMER
menu):
9. SET TIMER
You will see NEW TIMER on the top line. If no timers have been entered yet, the up and
down Menu buttons will do nothing. If there are other timers already in memory the up and
down buttons will cycle around them and will always include NEW TIMER in the loop if
there is empty space in the memory.
NEW TIMER
28
Installation
To enter a new timer you must be on the NEW TIMER screen. Then press OK. The display
shows UNIT NUMBER on the top line. Using the number keys, enter a valid number (1-16)
and press OK.
UNIT NUMBER
Say for example you enter 12. The top line displays TIMER 12 ON. The bottom line
displays a colon, :
TIMER 12 ON
Enter your desired ON time with the number keys followed by am or pm in the format
shown below, (or just press OK if you don't want to set an ON time). Press Clear if you
enter a wrong time.
TIMER 12 ON
12:34am
Then press OK. The top line displays TIMER 12 OFF. The bottom line displays a colon, :
TIMER 12 OFF
Enter the OFF time as above and press OK, (or just press OK if you don't want to set an
OFF time). Press Clear if you enter a wrong time. The display shows 1. DAILY on the
bottom line (top line blank).
1. DAILY
Using the up or down Menu buttons you can cycle around 1. DAILY, 2. ONCE ONLY, 3.
RANDOM, or 4. ARMED ONLY. Select the one of your choice and press OK. The display
again shows NEW TIMER. Now the up and down Menu buttons will cycle through the
entered events in the form:
12ON 12:34am
OFF 12:45pm
Note you can set a total of 12 "timer pairs" i.e., ON-OFF times. If you set an ON time with
no corresponding OFF time for that unit code (or vice versa) it still counts as a "timer pair."
RANDOM varies the time during the programmed hour. ARMED ONLY activates the timed
event ONLY when the system is armed (for a lived-in look when you're away).
29