Table of Contents
Advertisement
Optional X10 Lamp Modules
Setting the (optional) X10 Lamp
Module's Code
Using a small screwdriver, set the red
House Code dial to the same letter as
your Console is set to. Set the Black Unit
Code dial to your Security Code (see
page 26).
Ratings
The Lamp Module can be used to control an incandescent lamp rated up to 300W. It is
not suitable for other types of lamps such as fluorescent or energy saving lamps, low
voltage lamps, or lamps that include a dimmer control. Caution: Do not connect an
appliance such as a coffee pot or heater to a Lamp Module. It may damage the Module
and/or the appliance and could cause a fire hazard. Use an Appliance Module instead.
1.
Set the House Code
2.
Plug a lamp into
and Unit Code.
the Module.
Testing The X10 Module(s)
Make sure the lamp's switch is on. Plug the X10 Lamp Module into the same wall outlet
as your Console's power supply, press the number button on the Console that
corresponds to the Unit Code setting on the Module (1-16), then press On or Off. If the
Module turns on and off you can unplug the Module and move it to its permanent location.
If you can't control the module, visit www.x10.com/support for help.
UNIT CODE
DIAL
HOUSE CODE
DIAL
3.
Plug the Module into
the same wall outlet
as your controller (see
testing below).
36
Optional GE Lamp Modules
Setting the (optional) GE Lamp
Module's Code
Set the Unit Code dial on the front of the
GE Module to your Security Code. Must
be between 1 and 8. (See page 26).
Set the House Code on the GE Module(s) to match the House Code for the Console (see
page 26). To set the Module's House Code, remove the small tab labelled House Code on
the back of the GE Module using a small screwdriver. Set the House Code to match the
Console's House Code (the Console must use House Code A, B, C, or D if you want it to
control GE Modules).
Follow the instructions that came with the GE Module(s) and observe the ratings on the
back of the module: 1200W Max. resistive load, 600W Max. tungsten lamps, 1/3 HP
motor load.
Testing The GE Module(s)
Make sure the lamp's switch is on. Plug the GE Module into the same wall outlet as your
Console's power supply, press the number button on the Console that corresponds to the
Unit Code setting on the Module (1-8), then press On or Off. If the Module turns on and
off you can unplug the Module and move it to its permanent location. If you can't control
the module, visit www.jascoproducts.com for help.
UNIT CODE
DIAL
House Code A
shown
37
Advertisement
Table of Contents
