GE JSC1300 Owner's Manual page 12

Installation
Recording your outgoing phone message
Press either of the Menu up/down buttons (under the lid to the bottom left of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, so press 0000 on the keypad (under the lid to the bottom left of
the display), or enter your PIN if you changed it (see page 24). This clears the top line
and shows * for each number entered.
****
12:00 am
This takes you to the first level of the menu at step 1. This is the INSTALLATION level.
The display looks like this:
1. INSTALL
Press an up or down menu button until you reach the MESSAGE menu, and then press
OK (or press 4, instead of an up or down menu button, to go into the MESSAGE menu):
4. MESSAGE
Press 1 or 2 to select one of the options below:
1. RECORD
2. REPLAY
1. RECORD (This is your own alarm message).
2. REPLAY (This replays a previously recorded message).
22
Installation
Press 1 for RECORD , then press OK. The display shows:
PLEASE WAIT
Then:
SPEAK NOW
Clearly speak your message into the Console's microphone (up to 12 seconds max.). A
typical message could be: "There's an alarm in progress at (your address), at the end of
this message please press any button on your touch-tone phone to listen in." After you've
finished speaking, wait for the display shown below:
1. RECORD
2. REPLAY
Now press 2 for REPLAY. The display shows:
PLEASE WAIT
It then plays back your recorded message. Wait for the display shown below:
1. RECORD
2. REPLAY
Press Clear to back out of the menu. You are asked to confirm, 1. YES, 2 NO. Pressing 1
takes you back to the HOME CONTROL screen. Press 2 to stay in the INSTALL menu.
Note: you cannot record messages remotely via telephone.
23