CHAPTER 5: SETTINGS
This configuration can be used on a two-winding transformer, with one winding connected into a breaker-and-a-half
system. The following figure shows the arrangement of sources used to provide the functions required in this application,
and the CT/VT inputs that are used to provide the data.
Y LV
SRC 1
Phase CT
M1
Ground CT
M1
Phase VT
M5
Aux VT
None
5.5.4 Breakers
SETTINGS SYSTEM SETUP BREAKERS BREAKER 1(6)
BREAKER 1
B30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
Figure 5-68: Example of use of sources
D HV
AUX
SRC 2
SRC 3
F1+F5
None
None
None
None
None
None
U1
BREAKER 1
FUNCTION: Disabled
BREAKER1 PUSH BUTTON
CONTROL: Disabled
BREAKER 1 TAGGING:
Disabled
Range: Disabled, Enabled
Range: Disabled, Enabled
Range: Disabled, Enabled
SYSTEM SETUP
5
5-147