GE B30 Instruction Manual page 109
Bus differential system
Hide thumbs
Also See for B30:
- Instruction manual (626 pages) ,
- Communications manual (532 pages) ,
- Technical reference manual (252 pages)
Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
3.
Select the Internet Protocol (TCP/IP) item from the list, and click the Properties button.
4.
Click the "Use the following IP address" box.
5.
Enter an IP address with the first three numbers the same as the IP address of the B30 relay and the last number
different (in this example, 1.1.1.2).
6.
Enter a subnet mask equal to the one set in the B30 (in this example, 255.0.0.0).
7.
Click the OK button to save the values.
Before continuing, test the Ethernet connection.
1.
Open a Windows console window, for example by selecting Start > Run from the Windows Start menu and typing
"cmd" or clicking the Start button and entering "cmd".
2.
Type the following command, substituting the IP address of 1.1.1.1 with yours:
C:\WINNT>ping 1.1.1.1
3.
If the connection is successful, the system returns four replies similar to the following:
Pinging 1.1.1.1 with 32 bytes of data:
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Ping statistics for 1.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip time in milliseconds:
Minimum = 0ms, Maximum = 0ms, Average = 0 ms
4.
Note that the values for
time
5.
If the following sequence of messages appears when entering the
Pinging 1.1.1.1 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
B30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
and
vary depending on local network configuration.
TTL
ADD DEVICE TO SOFTWARE
command:
C:\WINNT>ping 1.1.1.1
3
3-59
Advertisement
Table of Contents
