Perforation Skip; Line Terminator - Printronix P5000LJ User Manual

Page Length Rep.
•
Inches/Page. All page length calculations are based on the inches
displayed on the panel.
•
Lines/Page. All changes in LPI or density will be changed accordingly.
The length of the page is the number of lines per inch, or lpi.
For example, if the form in use is 82 lines at 6 lpi, the page is physically
13.67 inches. Since 13.67 inches is not selectable from the Length in
Inches menu, change the representation to lines, then set the number of
lines to 82. The inches menu will display 13.6 inches although the printer
internally keeps the exact form length of 13.67 inches.
Max. Line Width
Set the maximum line width at 13.2 inches (the default) or 13.6 inches.
Face, CPI Delay
Allows the combination of different font densities on the same line.
•
Enable. Different font densities can be used on the same line.
•
Disable. Only the same font densities are allowed on the same line.
Graphics Density
Graphics can be printed in 60 DPI (the default) or 70 DPI.

Perforation Skip

•
Disable. Allows printing on page perforation.
•
Enable. You may set up a skip-over margin. For example, a skip-over
margin of one inch creates a one inch margin at the bottom of the page.
Display Functns
•
Disable. The default. Control characters are not printed.
•
Enable. Control characters are printed before they get executed. This is a
useful debugging tool.

Line Terminator

You can specify what will be used to indicate the end of a line. Four options
are available: LF after CR, CR after LF, CR after FF, and CR after VT. Each of
these options may be enabled or disabled independent of one another.
PCL-II Emulation
83