Tcp Access Lists - Printronix P5000LJ User Manual

TCP Access Lists

Within TCP/IP environments, the NIC can restrict host access to destinations/
queues and remote command (i.e.,
execution services. This is done using an access list similar in function to the
Unix .rhosts file.
To view the current access list on the print server, complete the steps below.
Note Access list settings are not configurable through the HTML forms provided
with the NIC.
1. Start a Telnet session with the NIC.
Syntax:
telnet P5000LJIPaddress
2. Log in as
no password by default (or your password for your home set).
3. List the current access list.
Syntax:
List tcpip
If the TCP access table entry list is empty, all hosts have access to the
NIC services. If there are entries in the list, only those hosts specified
have access to printing and remote command execution.
To add and delete access list entries, the commands are:
Syntax:
store tcpip tcp access add|del hostIPaddress|
networkaddress
reset
where hostIPaddress
network and
network.
Example:
store tcpip tcp access add 192.75.11.25
store tcpip tcp access add 192.75.12.0
store tcpip tcp access del 192.75.11.25
reset
Note Although the maximum number of entries in the access list is 10, each
entry can refer to a network rather than a specific host. This allows all
hosts on that specified network plus any individual hosts specified in the
list to have access.
rsh
root and press ENTER at the password prompt since there is
is the IP address of a TCP/IP host on your
is the address of a subnet on your
networkaddress
TCP Access Lists
, , and
rcmd remsh telnet
)
261