Printronix P5000LJ User Manual page 285

Table 24. LCD Message Troubleshooting Table (continued)
Displayed Message
ERROR: WRITING
TO FLASH
ERROR: WRONG
CHECKSUM
ETHERNET ADAPTER
BEING INITIALIZED
ETHERNET
DETECTED
EXHAUST FAN FLT
FIRMWARE ERROR*
FRAMING ERROR
HAM. COIL OPEN*
HAMMER COIL BAD
X, X, X,...
HB NOT INSTALLD*
Explanation
Hardware or software fault in flash
memory.
The printer received the complete
program but the checksum did not
match. The data was corrupted
during download.
NIC is processing the boot
procedure.
NIC has established
communication.
Sensors cannot detect current in
fan circuit.
Application software tried to
perform an illegal printer function
or damaged memory detected on
board.
Serial framing error. (Serial
interface.)
Electrical malfunction of one or
more hammer coils.
Coil # failed current test at power-
up.
Self-test does not detect hammer
coils.
Fault Messages
Action Required
Download the program again.
If the message occurs again,
call your authorized Printronix
representative. 1
Download the program again.
If the message occurs again,
call your authorized Printronix
1
representative.
None
None
Power off the printer and
remove the paper path. Check
that the fan cable connector is
connected. Check for
obstruction of vents and fan
airway, and remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on
the printer. If this message
recurs, contact your
authorized Printronix
1
representative.
Contact your authorized
Printronix representative.
Check your serial host
interface parameter settings; if
necessary, adjust them so that
they match the settings of the
attached host.
Contact your authorized
Printronix representative.
Record message, clear to
continue printing, and contact
your authorized Printronix
representative.
Contact your authorized
Printronix representative.
285
1
1
1