Printronix P5000LJ User Manual page 233

4. Look under the "Novell" section and find a row in the RPRINTER
category.
5. Click "Enabled" and enter the name used with the PSERVER.NLM started
in step 1 into the "Print Server Name" field.
Note If it is an NDS pserver, only enter the PSERVER name and not the context
(e.g.,
sales_ps
6. Enter the printer number of the printer you would like serviced into the
"Printer Number" field, and then select the destination on the NIC you
would like to use for output.
7. Repeat steps 4 through 6 for each additional printer you would like to
have serviced.
8. Click the SUBMIT button when done and physically re-power the printer
to make the new settings take effect.
Manual (Telnet) Method
1. Load a PSERVER on your Netware 3.x or Netware 4.x or Netware 5.x file
server (i.e., issue a
server).
Note If it is an NDS PSERVER on a Netware 4.x or 5.x file server, you must
specify the pserver name and context for
load pserver .sales_ps.sales.hp
2. Telnet to the print server. This will bring up a login screen:
telnet ipaddress
Note
If prompted for a User ID and password first, type in
press ENTER at the password prompt since there is no password by
default.
3. You should now see a prompt display that has the NIC's IP address
followed by a colon then
ipaddress:root>
4. At the prompt,
pservername
created in step 1.
Syntax:
store rprinter add pservername printernumber
P5000LJdestination
RPRINTER/NPRINTER Setup (Netware 3.x, 4.x, and 5.x)
).
load pserver pservername
.
root
the RPRINTER settings on the NIC. The
store
refers to the existing PSERVER.NLM on the file server
command on the file
pservername . For example:
root for the ID and
233