Printronix P5000LJ User Manual page 257

start fox|tts|loopb prn
start fox prn
Begin a debugging test on one of the I/O ports on the NIC. The tests
available are:
fox
tts
loopb Loopback test. Any input characters from the device attached
stop prn
stop prn
Stop an output test on an I/O port.
disable ioport|destination
disable prn
Disable an
destination
enable ioport|destination
enable prn
Enable an
destination
close tcp TCPindexnumber
close tcp 3
Force a TCP/IP connection between a TCP/IP host and the NIC to close.
The
TCPindexnumber
ping [-s] hostIPaddress [datasize [packetnumber]]
ping 192.75.11.30
another TCP/IP host specified by
ping
network.
bytes if no size is included in the syntax, and
number of requests to be sent.
Note To use a host or IP name instead of the address, you must have set the
DNS server on the NIC. Use the command
this.
telnet hostIPaddress [escapecharacter]
telnet 192.75.11.35
Start a Telnet session with another TCP/IP host specified by
hostIPaddress
resets the key sequence used to exit the Telnet session. It will return you
to the telnet> prompt where you can execute
command to find out exact escape characters if needed. The default
character is CTRL-].
A continuous stream of text sent to the attached printer. This
is a good test for troubleshooting hardware as long as the
attached printer supports text output.
A continuous stream of Gandalf 400C TTS-compatible text
sent to the attached printer.
to the I/O port is echoed back.
so that queued jobs are not printed, or disable a
ioport
so jobs can not be queued to it.
so that queued jobs are printed, or enable a
ioport
so jobs can be queued to it.
can be retrieved from "debug tcp" output.
is the datagram packet size which defaults to 64
datasize
on the NIC network. If
Miscellaneous Commands
on the NIC
hostIPaddress
packetnumber is the
set sysinfo dns...
is used, it
escapecharacter
quit . Use the keycode
to do
257