List Commands - Printronix P5000LJ User Manual

Chapter 13
Complete Command List

List Commands

These commands list the current or working settings for a particular section
within the command shell. To view stored settings in flash memory, you will
need to add in
commands. For example,
list stored prn
Normally these should match.
list arp
List the current ARP table that the NIC adheres to in a TCP/IP network.
list date
List the current date on the NIC.
list dest
List the current destination settings (e.g., names and mapped I/O ports,
models, and logpaths).
list diff
List the differences between the current settings and the stored settings in
flash memory. Normally, you want these values to match, so issue a
save
list ifc
List the current UTP interface settings (e.g., link integrity).
list key
List the license details and license key number.
list logins
List any active user logins on the NIC.
list logpath
List the current logpath settings (e.g., names and mapped destinations).
list model
List the current model settings (e.g., names and mapped destinations).
list pserver
List the current general print server settings (e.g., print server name and
Novell mode).
list prn
List the current parallel port setting (e.g., mode).
list rprinter
List any current RPRINTER definitions.
list snmp
List Trap Table containing SNMP Managers.
list sysinfo
List the current NIC system information (e.g., contact name and protocol
stacks enabled).
list tcpip
List all current TCP/IP network settings (e.g., IP address and subnet
mask).
254
stored within the beginning of any of the following
list prn
shows you the settings sitting in flash memory.
command followed by a reset
shows you the current prn settings but
.