Printer Control Menu - Printronix P5000LJ User Manual

Ethernet Speed
This menu option only appears if a 10/100Base-T network interface card
(NIC) is installed. The Ethernet Speed menu allows compatibility with different
systems and networks. The factory default is Auto Select.
•
•
•
•
•

Printer Control Menu

The Printer Control Menu allows you to choose the printer's behavior. Options
on this menu, as shown below, are described in the following pages.
PRINTER
CONTROL
Unidirectional
Disable*
Enable
Auto Select. (the default) This setting tells the 10/100Base-T NIC to
perform an auto detection scheme and configure itself to be 10 Half
Duplex, 10 Full Duplex, 100 Half Duplex, or 100 Full Duplex.
10 Half Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
10 Full Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
100 Half Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
100 Full Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
PMD Fault
Enable*
Disable
Auto Switching Submenu
Open Platen Slow Paper
@BOF Slew
Disable* Disable*
Enable Enable
To view options, press:
Down
Up
Next
Prev
To select an option, press ENTER.
To return to main menu, press
CLEAR.
To exit menu, press ON LINE.
* = Default Setting
Power Saver
Time
15 mins.*
(5 sec.-60 min.)
Disable
Instant
127