Super-Set Commands; Underline - Printronix SL5000 Series Programmer's Reference Manual

Chapter 2
Configuring the P-Series Emulation with Control Codes

Super-Set Commands

ASCII Code SFCC | } ;
Hex Code
Dec Code
Purpose
Comment

Underline

ASCII Code SFCC – n
Hex Code
Dec Code
Purpose
where:
Comment
Example
58
SFCC 7C 7D 3B
SFCC 124 125 59
Control code sequence used to introduce the super-set
commands.
Super-set commands affect the ASCII Emulation as a whole
regardless of the printer protocol currently active. The
commands are sent from the host in the data stream to the
printer, and provide the following capabilities:
•
Select a printer protocol
•
Change the page orientation
•
Define various font attributes, including typeface and
point size
•
Select proportional fonts
See Chapter 7, "Super-Set Programming," beginning on page
205 for further information on the Super-set commands.
SFCC 2D n
SFCC 45 n
Enables or disables automatic underlining of all characters.
n = 0 to disable automatic underlining (hex 00 or hex 30)
n = 1 to enable automatic underlining (hex 01 or hex 31)
When automatic underline is enabled, all characters, including
spaces, are underlined until disabled.
The following sample illustrates automatic underlining.