Working Inside The Digi Cm - Digi CM 32 User Manual

Chapter 14
Safety
US: UL1950
Canada: CSA 22.2 No. 60950
Europe: EN60950 (CB Scheme Report)

Working Inside the Digi CM

NOTICE: Do not attempt to service the Digi CM yourself, except following the
instructions from Digi Technical Support personnel. In such a case, first perform the
following actions:
• Turn off the Digi CM.
• Ground yourself by touching an unpainted metal surface at the back of the equip-
Replacing the Battery
A coin-cell battery maintains date and time information. If you have to
repeatedly reset time and date information after turning on your Digi CM,
replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the 3
Volt CR2032 battery only with the same or equivalent type recommended by the
battery manufacturer. Discard used batteries according to the battery
manufacturer's instructions.
Safety Instructions
CAUTION: Do not operate your Digi CM with the cover removed.
• In order to avoid shorting out your Digi CM when disconnecting the network cable,
• To help prevent electric shock, plug the Digi CM into properly grounded power
• To help protect the Digi CM from transients in electrical power, use a surge sup-
• Be sure that nothing rests on the Digi CMs cables and that the cables are not located
• Do not spill food or liquids on your Digi CM. If it gets wet, contact Digi Technical
• Do not push any objects into the openings of your Digi CM. Doing so can cause fire
Chapter 14
ment before touching anything inside your equipment.
first unplug the cable from the equipment and then from the network jack. When
reconnecting a network cable to the equipment, first plug the cable into the network
jack, and then into the equipment.
source. The cable is equipped with 3-prong plug to help ensure proper grounding.
Do not use adapter plugs or remove the grounding prong from the cable. If you
have to use an extension cable, use a 3-wire cable with properly grounded plugs.
pressor, line conditioner, or uninterruptible power supply.
where they can be stepped on or tripped over.
Support.
or electric shock by shorting out interior components.
Certifications
C e r t i f i c a t i o n s
87