Table of Contents
Advertisement
3.
Press Next to page through the submenu.
•
Serial Port and MAC address— Remain view only.
•
DHCP — Rotate either knob to select On or Off.
IP Address, Subnet Mask, and Gateway Address — Rotate the ADJUST
•
ADJUST
{
knob to change the selected octet.
Remote Configuration
The ISS switcher can be configured remotely via Extron Product Configuration Software (PCS) or Simple Instruction Set (SIS)
Commands.
PCS — To configure using PCS, install the software (available at www.extron.com) to a PC connected to the switcher via
•
Ethernet or the front panel USB Config port. For full instructions, connect to the device and click the arrow in the ISS tab,
then select the ISS Help File from the drop-down list.
•
Basic SIS Commands — To configure using SIS commands via an RS-232, USB, or Ethernet connection, use the Extron
DataViewer utility or a control system to send and receive SIS commands. The following table lists common SIS commands
and the symbol definitions. For a full list of SIS commands and variables, see the ISS 608 and ISS 612 User Guide at
www.extron.com.
NOTE:
For commands and examples of computer or device responses used in this guide, the character "0" is the
number zero and "O" is the capital letter "o."
Command
Input switch
Tie input to output (audio and
video)
Tie input to output (video only)
Tie input to output (audio only)
X!
KEY:
= Input number
X@
= Output number
Take effect select
Set Take effect
View setting
X1(
KEY:
= Take video effect
Take (with Cut, Dissolve, or Wipe effect selected)
Take
Take (with PIP or Video Key effect selected)
Begin effect
End effect
SIS Command
(Host to Device)
X!
X@
*
!
X!
X@
*
%
X!
X@
*
$
1 – 8 for the ISS 608, 1 – 12 for the ISS 612 (two-digit response with 0 padding)
1 = Preview
2 = Program
E
X1(
}
O1*
SWEF
2^
E
}
O1SWEF
0 = Cut
1 = Dissolve
%
%
%
[
knob to select an octet (blinking) and the
Response
(Device to Host)
X@
X!
]
Out
•In
•All
X@
X!
]
Out
•In
•Vid
X@ •
X! •
]
Out
In
Aud
X1(]
SwefO1*
X1(]
2 = Wipe
3 = PIP
]
Tke
]
Bsy1
]
Bsy0
]
Tke
]
Bsy1
]
Tke
]
Bsy0
Additional Description
X!
X@
Tie input
to output
(All)
X!
X@
Tie input
to output
(Vid)
X!
X@
Tie input
to output
(Aud)
X1(
Sets the Take effect to
View current setting (Default = 0)
4 = Video Key
Switch the previous and program
outputs per the preview switch
setting
Effect is underway
Effect is complete
Enables PIP or Video Key on
Program output
Effect is active
Ends effect and removes PIP
or Video Key from the program
output
Effect is complete
5
Advertisement
Table of Contents
Need help?
Do you have a question about the ISS 612 and is the answer not in the manual?
Questions and answers