Jet Pump Support - Sea-doo RXT iS 255 2009 Shop Manual

9. Reinstall coolant hoses on ride plate fittings,
pay attention to gear clamp positioning. See
following illustration.
smr2009-043-016_b
1. Gear clamp positioning
10. Install jet pump, refer to the
section.
11. Install iBR gate and VTS trim ring, refer to the
IBR AND VTS
subsection.
12. Install battery and electrical accessories sup-
port, refer to CHARGING SYSTEM
tion.
13. Refill cooling system and carry out a leak test.
COOLING SYSTEM
Refer to
14. Install all remaining parts in the reverse order
of removal.

JET PUMP SUPPORT

Jet Pump Support Removal
1. Remove the inlet grate and ride plate, see pro-
cedures in this subsection.
2. Remove the four screws retaining the pump
support to the ride plate.
smr2009-043-019_a
TYPICAL - TOP VIEW RIDE PLATE AND PUMP SUPPORT
1. Pump support retaining screws
smr2009-042
3. Sealant is applied between the jet pump sup-
smr2009-043-019_b
APPLY HEAT HERE
JET PUMP
sub-
Jet Pump Support Cleaning
1. Scrape off all excess sealant from jet pump sup-
2. Inspect pump support for cracks and other
subsec-
3. Clean jet pump support and hull surface with
subsection.
Jet Pump Support Installation
1. Ensure sealant contact areas are clean and dry.
2. Apply
smr2009-043-021_a
1. Apply loctite 5900 here
Section 07 BODY AND HULL
Subsection 03 (HULL)
port and the ride plate. Using a heat gun, heat
the base of the pump support to soften the
sealant and carefully pry the pump support off
the ride plate.
port, ride plate, and hull.
damages. Replace as necessary.
BRP HEAVY DUTY CLEANER (P/N 293 110 001)
eliminate grease, dust, and sealant residue.
LOCTITE 5900 (P/N 293 800 066)
plate and pump support as seen in the following
illustrations.
to
on the ride
503