Jet Pump Water Intakes; Bow Lights; Removable Stern Light - Sea-doo Speedster 200 Operator's Manual

32) Jet Pump Water
Intakes
Water is drawn up by the impeller
through these openings, minimizing
entry of foreign objects into the propul-
sion system.
WARNING
Keep away from intake grates
while engine(s) is/are on. Items
such as long hair, loose clothing or
personal flotation device straps
can become entangled in moving
parts resulting in severe injury or
drowning.

33) Bow Lights

Mandatory red and green lights. See
LIGHT SWITCH as mentioned earlier in
this section.

34) Removable Stern Light

Mandatory white stern light.
It is recommended to keep it in rear
storage compartment at all times ex-
cept when needed.
To remove from storage cover, pull it
out. Snap in place to store again.
F13L1EY
TYPICAL — STERN LIGHT IN STORAGE CLIPS
Installation
– Lift connector cap.
– Insert post in connector hole. En-
sure to align hole keyway with post
screw head.
– Firmly push downward to engage
terminals.
– Push lock ring downward. Turn until
locked. It may be necessary to
slightly turn it to allow its insertion
in the hole.
– Check light operation. See LIGHT
SWITCH as mentioned earlier in
this section.
1
F04L0LY
TYPICAL
1. Lift
2. Align screw in groove
3. Push downward
4. Turn to lock
CAUTION: Ensure dielectric grease
is present in connector area of light
to prevent corrosion.
2
3
4
49