Battery - Sea-doo RXT iS 255 2009 Shop Manual

Voltage Regulator/Rectifier Installation
Installation is the reverse of removal procedure.
However, pay attention to the following.
Lock voltage regulator/rectifier in position. Wiggle
it to make sure it is safely locked.
smr2009-033-006_b
1. Locked here
Reinstall remaining removed components.

BATTERY

Troubleshooting
SYMPTOM: DISCHARGED OR WEAK BATTERY
CAUSE
Battery posts and/or cable
terminal oxidized.
Loose or bad
connections.
Faulty battery (sulfated,
fretting, shorted plates
or cell, damaged casing,
loose post).
Burnt fuse(s) or faulty
rectifier.
Faulty stator.
Parasitic or "Key Off"
current loads.
smr2009-033
REMEDY
Clean battery terminals,
posts, and coat with
dielectric grease.
Check for wiring and
connector tightness,
frayed or broken wires.
Repair or replace cables
or connectors.
Replace battery.
First check fuse(s). If in
good condition, check
voltage regulator/rectifier.
Test stator and replace as
required.
Isolate, reduce or
eliminate such loads,
recharge battery as
recommended if vehicle
is not used for extended
periods of time.
Section 05 ELECTRICAL SYSTEM
Subsection 04 (CHARGING SYSTEM)
NOTE: "Key Off" or parasitic loads may be loads
due to installed accessories. Parasitic loads may
also be due to water infiltration in connectors, or
partial short circuits that slowly drain a battery
without causing a fuse to burn.
NOTE: A battery that continually necessitates the
addition of distilled water indicates an over voltage
situation. Carry out a CHARGING SYSTEM VOLT-
AGE TEST .
Battery Vent and Check Valve
WARNING
Battery caps do not have vent holes. Ensure
vent line is not obstructed and check valve is
functioning properly.
Check vent line condition.
smr2009-033-009_b
1. Vent line
Make sure that grommet of check valve is not
plugged.
Disconnect vent hose from battery.
smr2009-033-009_a
1. Disconnect here
301