Sea-doo RXT iS 255 2009 Shop Manual page 359

Section 05 ELECTRICAL SYSTEM
Subsection 07 (GAUGE)
The numerical and multifunction displays in the
digital screen can be used to display various indi-
cations, or for selecting modes of operation and
changing settings as explained in their respective
subsections.
smo2009-002-114_j
DIGITAL SCREEN
4) Indicator Lights
Indicator lights (pilot lamps), located in the
speedometer and tachometer indicator, inform
you of a selected function, a normal condition, a
system anomaly, or a serious malfunction.
An indicator light may be accompanied by a
scrolling message in the multifunction display.
PILOT
MESSAGE
LAMPS
DISPLAY
(ON)
MAINTENANCE
REMINDER
LOW or HIGH
BATTERY
VOLTAGE
LOW-FUEL
HIGH
TEMPERATURE
CHECK
ENGINE or
LIMP HOME
MODE
LOW OIL
PRESSURE
336
DESCRIPTION
Maintenance required
Low/high battery
voltage
Low fuel level, approx.
20% tank capacity,
14 L (3.7 U.S. gal.)
or fuel level sensor
disconnected
Engine or exhaust
system overheating
Check engine (minor
fault req. maint.) or
LIMP HOME MODE
(major eng. fault)
Low oil pressure
PILOT
MESSAGE
LAMPS
DISPLAY
(ON)
_
_
_
_
5) Fuel Level
A bar gauge located in the bottom RH side of the
digital screen continuously indicates the amount
of fuel in the fuel tank while riding.
smo2009-002-114_k
FUEL LEVEL INDICATION
When the fuel tank is full, 8 segments (bars) of
the indicator are turned on. The top segment is
not used.
When there is only 2 segments of fuel indicated
(approximately 20% fuel tank capacity or 14 L
(3.7 U.S. gal.), the low fuel indicator light will
come on to advise you of the low fuel condition.
INDICATOR LIGHTS
See
An audible warning (one long beep) will be heard
periodically as long as the low fuel condition ex-
ists.
6) VTS Position
The VTS position indication located in the bottom
LH side of the digital screen indicates the riding
attitude of the watercraft.
DESCRIPTION
CRUISE mode or
SLOW SPEED MODE
engaged
iBR system fault
O.T.A.S. system fault
Good GPS uplink
.
smr2009-036