Handlebar Grip - Sea-doo RXT iS 255 2009 Shop Manual

smr2009-037-041_a
1. Nozzle
2. Nozzle arm
3. Hexagonal screw
4. Nozzle link rod
5. Socket screw
6. VTS trim ring
Remove nozzle from watercraft.
Nozzle Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Apply
LOCTITE 243 (BLUE) (P/N 293 800 060)
hexagonal screw threads (or use new self-locking
screws).
Tighten hexagonal screws to 10 N•m (89 lbf•in).
Secure steering cable to nozzle. Refer to
ING CABLE
in this subsection.
STEERING ALIGNMENT
Perform the
cedure in this subsection.

HANDLEBAR GRIP

Handlebar Grip Removal
To remove handlebar grip, pull out cap and remove
screw.
smr2009-037-006_a
1. Handlebar grip
2. Handlebar grip screw
Pull out handlebar grip and remove grip insert
from handlebar.
smr2009-037
Section 06 STEERING AND PROPULSION
Subsection 01 (STEERING AND O.T.A.S.)
smr2009-037-007_a
1. Grip insert
NOTE: Verify grip insert for damage.
Handlebar Grip Installation
When installing the grip insert in the handlebar,
ensure that it is properly inserted in the slot at the
end of the handlebar tubing.
on
STEER-
, see the pro-
smr2009-037-008_a
1. Grip insert
Install handlebar grip on handlebar matching it to
the notch in the handlebar.
Apply
screw threads.
Install flat washer and handlebar grip screw.
NOTICE
wise screw will damage grip end.
Torque handlebar grip screw to 7 N•m (62 lbf•in).
Install cap.
LOCTITE 243 (BLUE) (P/N 293 800 060)
Ensure to install flat washer other-
on
363