Engine Oil Pressure Regulator - Sea-doo RXT iS 255 2009 Shop Manual

Section 02 ENGINE
Subsection 08 (LUBRICATION SYSTEM)
smr2009-023-007_a
1. Oil inlet
2. Oil outlet
Suction Pump Oil Strainer Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Apply
LOCTITE 243 (BLUE) (P/N 293 800 060)
threads of the suction pump cover screws and
tighten them to 9 N•m (80 lbf•in).
Position screws according to their length as
shown.
smr2009-023-008_a
1. Screws M6 x 25
2. Screws stainless steel M6 x 45
Torque suction pump cover screws as per se-
quence illustrated below.
98
smr2009-023-009_a
TIGHTENING SEQUENCE
ENGINE OIL PRESSURE
REGULATOR
The oil pressure regulator is located on the bottom
of the PTO housing.
on
smr2007-015-005_a
TYPICAL
1. Oil pressure regulator
NOTE: The oil pressure regulator system opens
when the oil pressure exceeds 400 kPa (58 PSI).
Oil Pressure Regulator Removal
Remove engine oil. See procedure in
CHANGE
in this subsection.
Remove:
– Oil pressure regulator plug
– Compression spring
– Valve piston
– Valve piston guide.
OIL
smr2009-023