Jet Pump Support - Sea-doo GTX DI 5563 2002 Shop Manual

Section 14 HULL/BODY
Subsection 02 (ADJUSTMENT AND REPAIR)
1. Hydraulic bottle jack
2. Riding plate
Cleaning
– Scrape off all excess of sealant from riding plate
and hull.
– Clean hull surface with acetone based solvent to
eliminate grease, dust and any residue of sealant.
Installation
All Models
Apply Loctite RTV silicone sealant (P/N 293 800 066)
as indicated by the shaded areas in the next illustra-
tions. Follow also the torquing sequence as shown
in the same illustrations.
GTX 4-TEC MODEL
14-02-12
GTX DI MODEL
NOTE: Apply Loctite RTV silicone sealant (P/N 293
800 066) as indicated by the shaded area.

JET PUMP SUPPORT

Removal
– Remove jet pump. Refer to JET PUMP.
– Remove inlet grate and riding plate.
– Remove ball joint, boot, nut, half rings and O-rings
from steering cable.
F05K02A
TYPICAL
1. Unscrew nut
– Remove ball joint, boot, nut, half rings and O-rings
from reverse cable.
www.SeaDooManuals.net
1
SMR2002-092_14_02A.FM